Maintenance Every Day Keeps the Repairman Away

• Wipe down daily with a soft cloth and remove any oils or product with a mild detergent.
• Check for looseness or movement not consistent with the normal operation of the table / chair.
• Check weekly to see that the table or chair operates at its full range of movement.
• Tighten all visible nuts and screws monthly / quarterly.

• Remove sealing gasket from inside of lid and wash the gasket with warm soapy water.
• Rinse gasket thoroughly and shake dry (do not wipe).
• Replace gasket in lid by tucking it evenly under all lugs, starting at gasket offset device.
• Clean interior and exterior with warm, soapy water, keeping all electrical parts dry.

• Remove any towels and wipe cabinet dry inside.
• Ensure operating temperature is in a safe range.
• Empty drip tray and leave door open.

• Empty water and rinse steamer jar.
• Dry the heating element.
• Make sure jar and gasket are clean and dry before replacing.
• Wipe steamer with a damp cloth.

• Clean lamp and arm with mild cleanser to remove any product buildup from your hands.
• Refer to cleaning instructions included with lamps that have polycarbonate lenses.

• Clean electrodes with hospital grade surface disinfectant, then wipe with a damp cloth.
• Clean handle with hospital grade disinfectant or 90% alcohol.

• Fill basin with warm water and detergent. Circulate through spa for at least 10 minutes.
• Drain detergent solution and rinse basin.
• Refill basin with clean water and circulate EPA registered hospital liquid disinfectant (bactericide, fungicide, and virucide) for at least 10 minutes
• Drain, rinse, and wipe basin dry with clean paper towel.

• Remove excess wax with a surface cleanser, like Remove or Clean Up from Clean + Easy.
• Ensure operating temperature is in a safe range.

• Empty water and wipe entire interior with a clean, damp cloth.
• Ensure operating temperature is in a safe range.

Check sanitizer bulb to be sure it operates at full strength.

• Clean pad and cover as needed.
• Ensure operating temperature is in a safe range.

• Check the water level and add water, if needed.
• Inspect hydrocollator packs for leaks. Scrub with soap and water if necessary.
• Ensure operating temperature is in a safe range.

• Clean with liquid disinfectant spray and rinse thoroughly with fresh water.
• Wipe all control knobs with clean, wet cloth, removing all salt or other treatment products.

• Remove any towels and wipe cabinet dry inside.
• Ensure operating temperature is in a safe range.
• Empty drip tray and leave door open.

• Clean brushes with antibacterial cleanser and warm water.
• Soak in hospital grade disinfectant for 10 minutes, then dry facing up.
• Clean handle with hospital grade disinfectant or 90% alcohol.

• Be sure paraffin is at the proper level prior to each use.
• Ensure operating temperature is in a safe range.

• Clean cupping glasses with warm, soapy water and hospital grade surface disinfectant.
• Clean handle with hospital grade disinfectant or 90% alcohol.